Add a processor to a clip

Click on a clip in the timeline (bottom panel) to select it and display its associated processors on the right panel.

If the categories are not expanded in the processor library (right-most panel), click on a category line, for example "Composition", to expand its content.

Double-click on a processor in the processor library (right-most panel), for example "Placement", to add it to the clip processors. You should get a new parameter box, for example "Placement", in the processor list (right panel):

You can then change the parameters of this new processor, for example, with the "Placement" processor: change the stereo picture position (X,Y), or its size (S):

Parameters can be changed in several ways, depending on the kind of element:

• simple click on a position of a slider
• click-and-drag on a slider
• mouse over a slider, then mouse wheel up/down, with or without the Shift key pressed
• mouse over a slider, then up/down or left/right arrow key, with or without the Shift key pressed
• click on blue arrow buttons on the right of a slider
• reset to the default value by a click on the round button on the right of a slider
• direct modification of the numerical value displayed in a text box
• click on a checkbox
• selection in a combo list
• etc...